The first log Greg puts on the Woodland Mills HM136MAX is there to help finish the stand beneath it. He built the base for 22 feet, then discovered the assembled track would run about a foot and a half longer than expected. That miscalculation gives the first cut a job to do and makes the setup worth following even if you’ve never shopped for a sawmill.
Greg and Katie start with a tractor that’s already been struggling with heavy loads, then work through track extensions, leveling feet, and the saw head as wind and fading daylight keep interrupting them. Their back-and-forth makes the work feel approachable, especially when they open every box looking for a manual that was in the mill’s storage tube. By the time Greg jokes that they’re on day 570, though, the repeated updates about the wind and what they hope to finish tomorrow have begun to slow the build.
Greg explains the machine best when he connects a feature to something he dealt with on his previous mill. He describes how the throttle activates the blade lubrication and why he expects that to cut down on waste. His explanation of the adjustable blade guide is similarly practical, tying its position to the size of the log. Both moments give viewers a reason to care about the parts going on the machine.
The backward wheel assemblies make for the clearest bit of troubleshooting. Greg and Katie show why the pieces are in the way and discover they can reverse them by undoing a few bolts. The lifting-cable snag has a similarly satisfying resolution when Greg realizes that turning the handle moves the pulleys far enough for the cables to reach. Some of the surrounding assembly chatter is harder to follow because they refer to pieces by pointing or saying “this” without consistently naming them.
The first milling session earns the excitement that builds through the earlier stops and starts. Greg explains why he needs to raise the log on blocks for the first cuts, then mills the piece he needs to extend the stand. Viewers get less detail on the final calibration. Greg reports adjusting the blade guides and wheels before cutting, and afterward he says the legs and a few other adjustments still need attention.
Greg’s enthusiasm after milling a log is easy to understand, given how long he’s waited to see what the machine can do. The power lift gets a recommendation before the pair have used it for milling, though, and they disclose their Woodland Mills ambassadorship in the closing moments. The finished log gives their first impressions some substance, while the short session leaves their broader praise for the mill’s power and ease of use largely untested.
Pros
- The short stand gives the first milling job a clear purpose.
- Greg and Katie show how they diagnose and correct the backward wheel assemblies.
- Greg’s comparisons with his previous mill explain why features such as throttle-activated lubrication matter in use.
- The discussion of the leveling feet addresses how the pair plan to adjust the track if frost shifts the base.
- The pair’s humor and visible excitement give an extended assembly project personality.
Cons
- Repeated updates about the weather and the remaining work slow the middle stretch.
- Some assembly exchanges are hard to follow because the parts being handled go unnamed.
- The final blade guide and wheel adjustments receive too little explanation for viewers following the setup.
- The early power lift recommendation and closing ambassador disclosure limit how much weight the product endorsement carries.
Watching Greg and Katie work through their mistakes is the best reason to spend time with this build. Their first log gives the project a satisfying finish, even with calibration still on the to-do list. As a record of what it takes to get a new sawmill cutting, it has enough practical detail to reward viewers who can live with the stop-and-start pace.











